|
Product Details:
|
| Communication Mode: | Full-Duplex & Half-Duplex | Product: | Huawei CE16808A - B05 CloudEngine 16800 Series Switches |
|---|---|---|---|
| Certification: | All | Function: | LACP, POE, QoS, SNMP, Stackable, VLAN Support |
| Brand Name: | Hua Wei | Place Of Origin: | China |
| Supply Ability: | 10 Set/Sets Per Week | Key Word: | 16800 Series Switches |
| High Light: | 16800 Series Huawei Cloud Engine Switches,LACP Huawei Cloud Engine Switches,Full Duplex Huawei Cloudengine |
||
Huawei CE16808A - B05 CloudEngine 16800 Series Switches
Overview
The CloudEngine 16808 supports DC, AC, and high-voltage DC power supply modes. The device can be connected to up to two power sources through power entry modules (PEMs). Each power module (PM) has two power inputs, and they convert the power supplied to the PEM to power the entire device.
The power supply units of the CloudEngine 16808 are located at the top of the chassis. The power supply units are PMs and power switches at the front of the chassis, and a PEM at the rear of the chassis. describes the functions of each unit.
|
No. |
Component |
Description |
|---|---|---|
| 1 | PM | Converts the power supplied to a PEM, and then powers the entire device through the power backplane and busbar. |
| 2 | Power switch |
Controls the power output of PMs. The two power switches back each other up. When one or both of them are turned on, the power output of PMs is enabled. NOTICE:
To ensure reliability, both power switches must be turned on when the device is running. |
| 3 | PEM |
Connects to a power source. One PEM can be connected to two power sources through its power sockets or terminal blocks. This design implements 1+1 power supply redundancy, ensuring that the device is not powered off if one power source in the equipment room fails. |
The CloudEngine 16808 must be equipped with one DC PEM. This PEM has 20 terminal blocks, every 10 of which are connected to one power source. Each DC PM has two power inputs, each of which comes from one power source in the equipment room. The DC PM converts and outputs the power to the power backplane, allowing the two power sources to back up each other. Figure 3-11 shows the DC power supply architecture of the CloudEngine 16808.
The CloudEngine 16808 must be equipped with one AC & high-voltage DC PEM. This PEM has 20 power sockets, every 10 of which are connected to one power source. Each AC & high-voltage DC PM has two power inputs, each of which comes from one power source in the equipment room. The AC & high-voltage DC PM converts and outputs the power to the power backplane, allowing the two power sources to back each other up.
The CloudEngine 16808 can be directly connected to a power source or indirectly connected one through a power distribution unit (PDU). Directly connecting a device to a power source uses cable connections similar to those in the DC power supply mode, and is not described here. The following describes the power supply architecture in the scenario where a device is indirectly connected to a power source through a PDU.
AC, high-voltage DC, and AC & high-voltage DC hybrid power supplies are supported.
Contact Person: Mrs. Laura
Tel: +86 15921748445
Fax: 86-21-37890191
